![]() Paste the configured link from the audio device in the URL field.Įnter the user name and password of the audio device. Select HTTP from the Type drop-down list. Type a name for the recipient, for example “Speaker”. Set the volume and number of times to repeat the clip. The motion detection application is configured and running in the camera. The Axis audio device and Axis network camera are located on the same network. This example explains how to set up the audio device to play an audio clip when an Axis network camera detects motion. Under Recipient, select your recipient (“Speaker test recipients”)Įnter a subject and a message, and click Save. Under Action, select Send notification to email. Under Speaker test status, select Didn’t pass the test. Under Condition, select Speaker test result. Set up the condition for sending an email when the speaker test fails: ![]() Under Action, select Run automatic speaker test. Under Schedule, select your schedule (“Daily at 6pm”). Under Condition, select Schedule and select from the trigger list Go to the device interface > System > Events > Rules. Check the email provider’s security policy to avoid delivery problems and locked email accounts. Some email providers have security filters that prevent users from receiving or viewing large attachments, from receiving scheduled emails and similar. Register with server every – Set how often you want the device to register with the SIP server for the existing SIP accounts.ĭTMF payload type – Changes the default payload type for DTMF. The reason for switching is to avoid fragmentation, and the switch can take place if a request is within 200 bytes of the maximum transmission unit (MTU) or larger than 1300 bytes.Īllow via rewrite – Select to send the local IP address instead of the router's public IP address.Īllow contact rewrite – Select to send the local IP address instead of the router's public IP address. ![]() UDP-to-TCP switching – Select to allow calls to switch transport protocols from UDP (User Datagram Protocol) to TCP (Transmission Control Protocol) temporarily. Under Additional, select additional options. ![]() Under Audio, select at least one audio codec with the desired audio quality for SIP calls. Use NAT traversal when the device is connected to the network from behind a NAT router or a firewall. Under NAT traversal, select the protocols you want to enable for NAT traversal. Some firewalls might block RTP traffic on certain port numbers. The default start port for media transport is 4000. RTP start port – Enter the port used for the first RTP media stream in a SIP call. Enter a different port number if required. The signaling traffic through this port is encrypted with Transport Layer Security (TLS). TLS port – The network port used for encrypted SIP communication. The signaling traffic through this port is non-encrypted. SIP port – The network port used for SIP communication. Under Call handling, set the timeout and duration for the call. To allow the device to receive incoming calls, select Allow incoming calls. Go to System > SIP > SIP settings and select Enable SIP. To better understand how P2P works, see Peer-to-peer SIP (P2PSIP).įor more information about setting options, see SIP. Use peer-to-peer when the communication is between a few user agents within the same IP network and there is no need for extra features that a PBX-server could provide.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |